AMP 106 T 1-Channel Mini Installation Power Amplifier 60 W @ 4 Ohm / 70V/100V
Part of the TICA® series, AMP106T it combines of compact size, passive cooling, and high efficiency – ideal for a wide range of audio installation applications.
The 60W Class-D amplifier, can drive low impedance or 70/100V line loudspeaker systems.
It's tiny 120 x 44 x 222 form factor and included mounting plates allow it to be installed discreetly almost anywhere; behind screens, under tables or even in in air-handling spaces and above plenum ceilings. Alternatively, it fits into ¼ 19 inch rack. Use the optional rack tray to slot up to four TICA® series products alongside each other and build a system to your exact requirements, using minimal rack space.
Terminal strip connections on the balanced line input and speaker output make wiring easy.
With remote control connectivity for third-party devices, you can adjust volume or put the power amplifier into standby mode at any time, even when it's hidden. Optional auto-standby saves power when no audio is running.
The perfect solution for professional installers and users looking for a compact, highly efficient and easy-to-integrate solution.
|Product type||Installation power amplifier|
|Music sources||2 balanced stereo line inputs|
|Powered outputs||1 with output mode selector (Low-Z/High-Z)|
|Nominal input sensitivity||8.5 dBu (Sine 1 kHz, Gain max)|
|Nominal input clipping||18 dBu (Sine 1kHz, Gain 0dB)|
|Input connector||2 x 3.81mm Terminal Block 3-pin|
|Standby wake up threshold||- 30 dBu|
|Amplifier Outputs||High-Z: 70V or 100V outputs, Low-Z: 4 ohm minimum load|
|Connector||4 - pin terminal block (pitch 5.08mm)|
|RMS Power ( W )||60 W (Continuous sine wave 1kHz, 4 ohm load)|
|Power ( Peak ) (W)||72 W (100 msec sine 1kHz Burst @ 4 ohm load)|
|Frequency range||15 Hz - 20 kHz (LO-Z, -1 dB), 20 Hz - 20 kHz (HI-Z, -1 dB)|
|High Pass Filter||110 Hz|
|Protection circuits||DC, DC protection, over-current, short circuit, thermal overload, Undervoltage|
|Operating voltage||100 V AC - 240 V AC, 50 - 60 Hz|
|Secondary connector||Terminal Block 5.08mm 2-pole|
|Idle power consumption||2 W (no signal input)|
|Standby power consuption||< 1 W|
|Operating temperature ( non-condensing )||0°C - 40°C; < 85% humidity, non condensing|
|Time to Auto-standby||20 Min.|
|Dimensions (W x H x D) ( height with rubber feet )||142 mm x 53 mm x 221.7 mm|
|Accessories||Rack mounting hardware|